Room correction may have reduced a previous bass rise or changed trim / target behaviour.
Test: Compare correction on/off at the same master volume and measure 20–120 Hz.
This sample is static and does not call the Research Engine or consume API credits.
“My subwoofer output became much weaker after calibration. What should I measure before raising the subwoofer level?”
The first priority is to determine whether the perceived loss is a simple level change or destructive interaction around the crossover / modal region. Raising gain before measuring can hide the cause and reduce headroom.
Room correction may have reduced a previous bass rise or changed trim / target behaviour.
Test: Compare correction on/off at the same master volume and measure 20–120 Hz.
A crossover-region dip can sound like reduced bass even when raw subwoofer level is adequate.
Test: Measure the subwoofer alone, mains alone, then combined.
Reference-level compensation, crossover changes or source-specific processing can change perceived balance.
Test: Verify crossover, trims and dynamic-processing settings before changing hardware gain.
Run repeatable REW sweeps with correction off and on, then compare sub-only and combined responses. If the loss is broadband, investigate trim / target level. If it is frequency-specific, investigate timing, placement and crossover interaction before EQ.
Room-correction and bass-management settings should be verified from the processor’s own documentation.
Individual and combined frequency-response measurements can distinguish level loss from cancellation.
Owner reports can reveal recurring behaviour, but should not replace measurement or official settings documentation.
Demo only: a live AV Evidence analysis would include current source links, equipment-specific context, disagreement between sources and research metadata.